Alroc XLPE enables a chamfer of 30 mm at the extremity of the insulation of MV cables. For 14-40mm cable diameter.

The red SR stylus can remove the outer semi-conductor without touching the primary insulation located underneath.
4 scoring depths: 0.4mm / 0.7mm / 0.9mm / 1.1mm
Diameter: ø16 - 58 mm 
Must be used with the following too

Alroc LH4 cable tools used by MV-HV jointers to remove the insulation.
Prepare the cable ready for the installation of joints, terminations or connectors.
Maximum cutting depth: 29mm
Cable diameter from 80 to 110mm.
Length 640m

The silver SRC-D stylus can remove the peelable semi-conductor without touching the primary insulation located underneath.
4 scoring depths: 0.4mm / 0.7mm / 0.9mm / 1.1mm.
Diameter: ø16 - 58 mm.
Must be used with the followin

Alroc LH3 cable tools used by MV-HV jointers to remove the insulation.
Prepare the cable ready for the installation of joints, terminations or connectors.
Maximum cutting depth: 24mm.
Cable diameter from 60 to 80mm.
Length 460m

The gold SRC stylus can remove the peelable semi-conductor without touching the primary insulation located underneath.
4 scoring depths: 0.4mm / 0.7mm / 0.9mm / 1.1mm.
Diameter: ø14 - 58 mm.
Must be used with the following to

Alroc LH2 cable tools used by MV-HV jointers to remove the insulation to prepare the cable ready for the installation of joints, terminations or connectors. 
Maximum cutting depth: 17mm.
Length 425mm, Width 105mm, Height 85mm.<

ALROC stripping tool for cable from Ø14 to 40mm.
Removes the bonded semi-conductor from MV and HV cables.
Creates a chamfer on the semi-conductor layer to facilitate the installation of joint, termination or connector.
Adjust